This really is an older thread, you may not receive a reaction, and will be reviving an old thread. Please look at creating a new thread.

Typically, the lesser the bore of the particular gauge getting used, the slower the powder has to be, to manage pressures. Similarly the heavier the payload in a certain gauge, the slower the burn up fee for your weighty loads needs to be.

He said a singe phase can be Okay because the bushing has the perfect time to fill. Observing how all I had was the 650 I just held the tackle down and rapped the powder bottle - dilemma solved. But, I don't buy 800X anymore.

Very first thing is after you stuffed the bottle with powder be certain the powder is "settled" from the bottle. If you don't do this it will never fall consistent the powder flakes are large.

Called Mec and they stated to use merely a Jr for 28ga when employing 800X. Stored working with it Along with the 650 but as proposed, I'd personally rap the powder bottle With all the manage down so it could fill the bushing. No additional challenges.

This really is an more mature thread, you might not get a reaction, and could be reviving an aged thread. Be sure to take into account making a new thread.

Include to quotation Only exhibit this consumer #15 · Jul one, 2011 (Edited) I've a idea about what is happening with the light (135gr) bullets and 800-X. About 6 months ago, I'd a half-baked concept to build a means to shoot 22 cal air rifle pellets out of my .22 LR (I don't individual an airgun now). The concentrate on was going to be starlings off the yard hen feeder. In any case, I pulled some bullets from some low-cost 22 ammo, dumped the powder, and afterwards loaded 1gr with the swiftest powder I have on hand, that is Bullseye. The strategy was to chrono the velocity and do the job up to about 1000fps. The only real dilemma was that I was only capable of get a single outside of about ten rds to truly burn up the powder and speed up the pellet out on the barrel at a good velocity. On The remainder, just the rimfire primer burned, leaving a mess of unburnt Bullseye within the barrel. The situation is the fact smokeless powders burn up speedy underneath intensive stress, as is often viewed by lighting several grains of powder without any force.

Assume some off sounding shells if you are shooting a .750 bore shotgun in cold weather conditions w/cold shells.

Incidentally, That is only based upon remembered "in field" measurements and shouldn't be taken as fact. Make sure you Really don't Believe This is certainly reality and thrust further than tension signs. At this time This is certainly absolutely nothing greater than a curious observation and lead to for dialogue.

There may be reg/rec difficulties once you attain significant mileages, along with the chain adjuster on the single-sided hub will seize if it doesn’t get a regular squirt of GT85 wherever the 800x pinch bolt goes.

“Enlighten the people usually, and tyranny and oppressions of the body and thoughts will vanish like evil spirits with the dawn of day.” ― Thomas Jefferson

This can be an older thread, you may not receive a reaction, and will be reviving an previous thread. Remember to take into account making a new thread.

I use Dillon and RCBS measures but by no means could get constant costs. ls there a Particular approach that works with huge flakes? I liked the final results to the focus on, 800X powder but had to weigh each and every charge. l gave up on it for that purpose.

I guess in the long run Taterhead is right. I feel there's a wide range of sense in the concept that They're masking their butts due to 800-X's weak metering attributes. I also concur that there are several Odd strain properties which might be restricting them.